ClearOne V-There 2100 Guide de l'utilisateur télécharger pdf (Page 30)

4 - 2

you are programming. (See Primary/Alternate Data Formats on page

4-17 for further information.)

Step 3. Terminal Type

Refer to Terminal ID Table (page 4-4) and locate the Terminal ID

number for your PC. Scan three numeric bar codes on the inside back

cover to program the scanner for your terminal ID (you must enter 3

digits). For example, scan 0 0 3 for an AT wedge.

Note: 099 indicates all terminal types.

Step 4. Code I.D.

In the Symbology Charts, beginning on page A-1, find the symbology to

which you want to apply the data format. Locate the Hex value for that

symbology and scan the 2 digit hex value from the Programming Chart

inside the back cover of this manual.

If you wish to create a data format for all symbologies, with the excep-

tion of some specific symbologies, refer to B8 (page 4-14).

If you are creating a data format for Batch Mode Quantity, use 35 for

the Code I.D.

Note: 99 indicates all symbologies.

Step 5. Length

Specify what length (up to 9999 characters) of data will be acceptable

for this symbology. Scan the four digit data length from the

Programming Chart inside the back cover of this manual. For example,

50 characters is entered as 0050.

Note: 9999 indicates all lengths.

Step 6. Editor Commands

Refer to Data Format Editor Commands (page 4-4). Scan the symbols

that represent the command you want to enter. 94 alphanumeric

characters may be entered for each symbology data format.

Step 7. Scan Save to save your data format, or Discard to exit without saving

your changes.

Enter Data Format

Save

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 151 152

Pas de commentaire

ClearOne V-There 2100 Guide de l'utilisateur Page 30