ClearOne V-There 2100 Guide de l'utilisateur télécharger pdf (Page 18)

2 - 6

code has been encountered. Scan the bar code below, then set the delay

(from 1-3,000 milliseconds) by scanning digits from the inside back cover,

then scanning Save. Default = 500 ms.

Preferred Symbology Default

Scan the bar code below to set all Preferred Symbology entries to their

default values.

Output Sequence Overview

Require Output Sequence

When turned off, the bar code data will be output to the host as the sled

decodes it. When turned on, all output data must conform to an edited

sequence or the sled will not transmit the output data to the host device.

Note: This selection is unavailable when the Multiple Symbols Selection is

turned on.

Output Sequence Editor

This programming selection allows you to program the sled to output data

(when scanning more than one symbol) in whatever order your application

requires, regardless of the order in which the bar codes are scanned.

Reading the Default Sequence symbol programs the sled to the Universal

values, shown below. These are the defaults. Be certain you want to

delete or clear all formats before you read the Default Sequence symbol.

Note: You must hold the trigger while reading each bar code in a sequence.

Note: To make Output Sequence Editor selections, you’ll need to know the

code I.D., code length, and character match(es) your application

requires. Use the Alphanumeric symbols (inside back cover) to read

these options.

Preferred Symbology Time-out

Preferred Symbology Default

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 151 152

Pas de commentaire

ClearOne V-There 2100 Guide de l'utilisateur Page 18