ClearOne V-There 2100 Guide de l'utilisateur télécharger pdf (Page 22)

2 - 10

Require Output Sequence

When an output sequence is Required, all output data must conform to an

edited sequence or the sled will not transmit the output data to the host

device. When it’s On/Not Required, the sled will attempt to get the output

data to conform to an edited sequence but, if it cannot, the sled transmits

all output data to the host device as is.

When the output sequence is Off, the bar code data is output to the host as

the sled decodes it. Default = Off.

Note: This selection is unavailable when the Multiple Symbols Selection is

turned on.

Multiple Symbols

When this programming selection is turned On, it allows you to read multiple

symbols with a single pull of the trigger. If you press and hold the trigger, aim-

ing at a series of symbols, it reads unique symbols once, beeping (if turned on)

for each read. The sled attempts to find and decode new symbols as long as

the trigger is pulled. When this programming selection is turned Off, the sled

will only read the symbol closest to the aiming beam. Default = Off.

Required

On/Not Required

*Off

* Off

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 151 152

Pas de commentaire

ClearOne V-There 2100 Guide de l'utilisateur Page 22