ClearOne IMPRESS IM100 Manuel d'utilisateur télécharger pdf (Page 16)

14 tEChnICal SUPPORt: 800.283.5936

VERIfyIng thE nEtwORK SEtUP

Once the IMPRESS networking hardware has been connected and its settings have been configured,

your Network Administrator should verify that the network is operating properly.

To verify that data can reach the IMPRESS IM100 unit, use a PC on the same network. Open a Com-

mand prompt on the PC, then type in a “ping” command:

ping x.x.x.x

Substitute your IP address for the “x.x.x.x” shown above. For example, if the IP address of your

IMPRESS unit is “10.1.1.4”, then you should type:

ping 10.1.1.4

If your network connection is successful, you should see results similar to the following:

C:\Windows>ping 10.1.1.4

Pinging 10.1.1.4 with 32 bytes of data:

Reply from 10.1.1.4: bytes=32 time<10ms TTL=255

Ping Statistics for 10.1.1.4:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss).

If a connection cannot be established between the IMPRESS and your networked PC, you should

repeat the hardware and software setup steps, verifying your settings. Pay particular attention to

the IP address and Subnet value.

If the above test still fails, have your Network Administrator contact ClearOne.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 82 83

Pas de commentaire

ClearOne IMPRESS IM100 Manuel d'utilisateur Page 16